LAST EDITED ON Apr-12-15 AT 02:05PM (MST)[p]Absolutely terrible morning to go out and shoot, but I was dying to try out the Crossfire. 40 degrees and 20-25 mph wind does not make for good accuracy, especially shooting off the hood of the vehicle. When the weather gets a little better, I will go out to the real range and shoot off the concrete bench and a good sand bagged rest. That will allow for accurate shooting and load developement.
Got it on the paper first shot, and it was about a foot low. Using all lead 348 grain Powerbelts and 100 grains of Pyrodex "P" powder. That always seems to shoot well in my Whites. Tweaked it in to a 2" group, 2" high at 50 yards then moved a new board out to 100 yards in the sage. Really like how clear it is, and easy focusing. The knobs under the turret covers are large and easy to use. No coins or screwdriver required. Crosshairs don't seem heavy at all out in the sunshine, but they do cover 4-6" at 100 yards.......
I fired a 4-shot group first, just one after another, and walked down to check. Very good but way right. Adjusted it to the left some and shot a couple more. When I went down and checked them, it was too far left, and I realized the clicks were 1/2" MOA instead of 1/4". Rookie mistake of not reading the turrets closely! Went back a couple clicks the other direction and final two shots were dead center. Moved the board out to 200 yards and the final two shots at long range were centered, and about an average of 8" low. This should be a great set up, if I can draw a muzzy deer tag this year.
Oh yeah, because of the low power, you can see a lot of the barrel in the scope, but it is not too distracting. The nice thing is, it lines the cross hairs up perfectly with the barrel and front site and lets you know if you are canting the rifle at all.