mightyhunter
Very Active Member
- Messages
- 1,179
I went to the SLC Hunt Expo last week. I was looking for a Euro Mounting System for a dead head bighorn ram I found in 2017. I had already done the cleaning and bleaching of the skull and bondoed the horns onto the skull.
There is no doubt that euro mounting bighorn sheep skulls involves a lot of weight. The Skull Max Mountain Mount worked perfectly on the sheep skull. The clamp and ball bearing system is ingenious. The fit and finish is also great. I set the skull on my trophy room wall about 7 ft. in the air and clamped it down tight. It isn't going to go anywhere. I am impressed. These boys know what they are doing. If I had any complaint it would be the two cheap deck screws they give you for mounting the wall bracket to studs. I switched them out for something heavier.
A great product.
just sayin...mh
There is no doubt that euro mounting bighorn sheep skulls involves a lot of weight. The Skull Max Mountain Mount worked perfectly on the sheep skull. The clamp and ball bearing system is ingenious. The fit and finish is also great. I set the skull on my trophy room wall about 7 ft. in the air and clamped it down tight. It isn't going to go anywhere. I am impressed. These boys know what they are doing. If I had any complaint it would be the two cheap deck screws they give you for mounting the wall bracket to studs. I switched them out for something heavier.
A great product.
just sayin...mh