M
massey_muley
Guest
Am I reading this right? According to the B&C website it says you measure all points on the outer edge starting at the point where it intersects the main beam, with the exception being G3 which is measured from where it meets G2.
So, In the following picture, would you measure G2 from point 1 where it intersects the beam, or point 2, where it meets the part of the main beam you measure.
Or am I totally off and is it measured at point 3
So, In the following picture, would you measure G2 from point 1 where it intersects the beam, or point 2, where it meets the part of the main beam you measure.
Or am I totally off and is it measured at point 3