Recent content by bdog35

Brand new still in the box scope. Never been out of the box, need to sale as soon as possible. They are 1350.00 at sportsman’s warehouse. Asking 1250.00 or best offer , if interested ask for Blake , thanks for looking. Text is best or phone calls during regular business hours.

I have always wondered why this state sells tags for deer and elk mainly antlerless that cannot be used by the public and how many go unsold and wasted. The only chance is a very small allotment for the CWMU. My question is how do we let these landowners know that we mean them no harm, we don't...

I drew a cow tag in the ferron canyon area, I'm not that familiar with the area , if anyone knows the area that would be willing to offer some advice on where to hunt I would greatly appreciate the help. We don't have a lot of time to scout but we have some knowledge of the twelve mile canyon...

Yes it is a viper .

I am here to report that rcbs dies do not work on a Lee press . I bought a Lee die and my brass now fits in my rifle. If the right deal comes along for my wsm I will listen to it and make a decision at that time. Thanks to the community for all the advice on how to solve this problem that I have...

It's a Weatherby Vanguard S1 , are you interested in the scope or no? The scope is a vortex viper in the 6.5-20x50.

I'm not getting the cam over because I have a Lee press and so it's not sizing or setting the shoulder back like it would with a rcbs press.

I've adjusted the die all the way in and every where in between and I'm not getting the results that others are getting . It's still not sizing the way it's supposed to.

How do you bump back the shoulder? Is it a tool that I need? This is getting very frustrating.

I tried it last night and brass fired in my gun will not chamber, so I went back and sized it again and it still won't chamber. I tried brass that were under trim to length at this point I'm all but convinced that the die is bad. To be clear the brass was under 2.09 that the manual says is the...

Thanks to all for the advice I'll try the new brass and see what happens. I may even send my dies back to Rcbs and cover my bases.

I have a Lee press and Rcbs dies. When I set up the dies I raise the ram until it bottoms out, lower the ram adjust the die in about 1/2 turn in and tighten the lock ring.

Thanks for the help , does a gunsmith have to check and measure the chamber, Then is that info used to make the dies?

Thanks for the advice I will get new brass and try it. Where do you get custom dies? I will look around for new brass and see what happens.

Yes I bought some once fired brass that was not fired in my gun and that's where the problem started. Brass for this caliber is hard to come by. Is the problem really a sizing issue or something different. I trimmed and sized the brass in small quantities to see what worked and it just didn't...