Platemaker4312
Member
- Messages
- 28
I really need some guidance on this problem.
I have a Vortex Viper PST Gen 2 5x25x50 30mm scope mounted with Talley Steel rings on a Weatherby MKV 300 WBY mag. The first go round I had the scope leveled and torqued to Vortex specs. 18in/lbs. bore sighted scope and went to sight in. After about 8 shots noticed scope had slipped in rings. went back and lapped rings to where there is about 99% bearing contact in the rings. Tightened down rings. Bore sight and off to sight in. After one shot scope slipped again. Is there an issue with Talley steel vertical mount rings and Vortex scopes. Really lost.
I have a Vortex Viper PST Gen 2 5x25x50 30mm scope mounted with Talley Steel rings on a Weatherby MKV 300 WBY mag. The first go round I had the scope leveled and torqued to Vortex specs. 18in/lbs. bore sighted scope and went to sight in. After about 8 shots noticed scope had slipped in rings. went back and lapped rings to where there is about 99% bearing contact in the rings. Tightened down rings. Bore sight and off to sight in. After one shot scope slipped again. Is there an issue with Talley steel vertical mount rings and Vortex scopes. Really lost.