Recent content by camokid

  1. C

    Royal Ivory CWMU - Elk

    Sorry for hacking this thread. Hopefully it helped others
  2. C

    Royal Ivory CWMU - Elk

    Thanks for the info! Just curious how you know so much about it since you haven't hunted it? No offense or disrespect. I know they give you three days to hunt. What's realistic or plan on full 3 days? Also what is the hunting conditions like? Drive around, hike to look for elk. Sit meadows? ect?
  3. C

    Royal Ivory CWMU - Elk

    What do you mean lousy? Very interested in maybe doing this cow elk hunt. Any and all details would be helpful. Thanks
  4. C

    Royal Ivory CWMU - Elk

    How is the antlerless cow elk hunt? What's it like ect?
  5. C

    Nolser Etip Handloads

    It's just what I have.
  6. C

    Nolser Etip Handloads

    I'll start OAL with what Nosler says in the book.
  7. C

    Nolser Etip Handloads

    Yes, it is a factory Remington 700 CDL
  8. C

    Nolser Etip Handloads

    Thanks! That was my thinking at least. Never done it that way with the RUM
  9. C

    Nolser Etip Handloads

    I'm looking at starting to load some 168 grain Etips for my 300 Rum. And then 30-06 with IMR4350 I know they say start at the low load data. Has anyone done so? With components hard to get I was thinking of doing 1 grain increments to check for pressure first before doing 3-5 round group test...
  10. C

    Too much pressure? 300 RUM

    Thanks for the info. Like you said I'm not going to sweat it yet
  11. C

    Too much pressure? 300 RUM

    Yes it's a factory Remington 700 CDL
  12. C

    Too much pressure? 300 RUM

    So i did some backtracking and remeasured my C.O.A.L.... BIG mistake on my part, and it was around 3.600 with cheap digital calipers, with the 180 grain Accubond. I since have upgraded to the Lyman Dial stainless steel calipers and the Lyman measured 3.645 - 3.650. Which is .45-.50 thousands...
  13. C

    Too much pressure? 300 RUM

    Yeah it just the primer that bothers me so far, of the crater and very very slight flattening. I'm touching holes at 100 yards so my load is where I'm wanting to stay and not push max loads. Why dump the gun if not fixing the firing pin?
  14. C

    Too much pressure? 300 RUM

    LAST EDITED ON Nov-13-17 AT 09:59PM (MST)[p]My bad... Great comment! Yes I'm trimming to 2.850.
  15. C

    Too much pressure? 300 RUM

    I've been waiting for mtmuley to chime in. Thanks for the wealth of knowledge ya'all are inputting. I'll learn all I can for sure. Thank ya kindly
See more
Back
Top Bottom