LAST EDITED ON Mar-14-05 AT 11:12PM (MST)[p]Just a friendly reminder, when you adjust the trigger for a lighter pull, be sure to perform a safety check on the trigger to be sure it will not accidently fire. With empty gun, work the bolt to put gun in firing or cocked position.Safety off, strike the bolt area and cocking handle with a rubber mallet to see if it will jar off. also put safety on and pull trigger with about 20 lbs pressure, then click safety off to check if firing pin will fall. Do this several times, you may be surprised and find you now have a unsafe gun because you adjusted it too light and have a unsafe sear engagement. If you do not have a rubber mallet, and the rifle has a rubber butt pad, slam the pad on a hard floor several times to try and jar the sear off. you should also work the bolt very hard and rapid up & down and see if that will jar the sear off.
If it does not jar off, you should be ok, if it does jar off, you need to adjust the sear to a harder trigger pull. 5 ounces of pull can make the difference between a safe or unsafe sear engagement.
Most rifle makers seal the adjustment screw, and will know if the seal has been tampered with. they will assume no further liability, and if you have a accidental discharge and someone is harmed by the discharge, you have bought the farm in a civil lawsuit.
RELH