Setting the unit of measure
The LEICA RANGEMASTER CRF 1600 can be set to
metric units or the Imperial units more commonly
used in the USA, i.e. either meters/Celsius/millibars
or yards/Fahrenheit/PSI (pounds per square inch) for
distance/temperature/atmospheric pressure respectively.
This setting also determines the holdover display
(in centimeters or inches) and the available ballistic
curves
Setting:
1. Briefly press the main button (1) (<3s).
? The reticule appears.
2. Press and hold the secondary button (2) (≥3s).
? appears below the reticule. The display
flashes to indicate that a setting can be made.
Note:
For all settings: The relevant displays disappear 3
seconds after you last press one of the two buttons.
The previously saved settings/values are retained.
3. Briefly press the secondary button twice.
? appears below the reticule.
4. Briefly press the main button.
? disappears, and the reticule and continue
to flash.
5. Select your preferred units of measure by (repeatedly)
pressing the secondary button, for Imperial
as used in the USA, or for metric.
? The relevant displays continue to flash.
Note:
The current setting can always be seen in the display
? if metric values are selected, a dot appears to the
bottom right of the reticule.
6. Save your setting by briefly pressing the main button.
? The saved setting and the reticule light up continuously
for 2 seconds for confirmation and
then disappear.
