1911
Long Time Member
- Messages
- 6,197
I've got a fire rated liberty safe that doesn't have a pass through. I know punching a hole will somewhat diminish the fire rating but I only need a hole large enough to pass some 16-2 zip chord in for a heating rod. Also I figure the humidity risk is far greater than what I will lose in fire rating under the current circumstances.
Anyone done this? Any huge regrets or pitfalls to avoid? I've even thought of pinching some Tstat wire in the corner of the door...only needs to run 15 watts I worry if I do that I may pinch a wire and cause headaches with a short.
I've never worried much about a humidity rod before but the temps have been higher where it was before.
Anyone done this? Any huge regrets or pitfalls to avoid? I've even thought of pinching some Tstat wire in the corner of the door...only needs to run 15 watts I worry if I do that I may pinch a wire and cause headaches with a short.
I've never worried much about a humidity rod before but the temps have been higher where it was before.