trophyhunter
Very Active Member
- Messages
- 2,197
I have been loading for 50 years. I have an issue and looking for input. I purchased RCBS dies in .308. I adjusted the sizing die then went to the loading die, I have been trying to adjust the bullet depth. I tried three Winchester cases and here?s my problem. I ran a sized empty case perfectly into the die. As I insert a bullet into the case and push it up into the die. The bullet starts to go into the case and after about 1/4 inch into the case the entire nick of the case collapsed. These are new out of the bag never shot Winchester cases. Do you think I have defective cases are they to soft ? I haven't tried some once shot other cases yet. Been busy and haven't tried other cases yet. Anyone else had this issue?
))))???->
))))???->